Help

Start a discussion
UNSOLVED

Gostev

updated

12 years ago

G

Gostev

13 Posts

0

3897

December 22nd, 2014 09:00

uemcli: shell mode for VNXe 3200

Does uemcli have mode, where I should not specify address, user and password in each command?

So uemcli connects to VNXe 3200 storage, and then I can execute any command (like SSH shell mode)

Now when I executing command with uemcli, I should specify address, user and password in each command. And I think, it takes significant amount of time just for establishing connection with storage:

uemcli.exe -d

-u -p /stor/prov/luns/lun -id sv_1 set -snapHosts "Host_12,Host_2"

Storage system address:

Storage system port: 443

HTTPS connection

ID = sv_1

Operation completed successfully.

  • R

    reedic

    28 Posts

    1537

    0

    Posted December 22nd, 2014 10:00

    Yes, you can save access credentials and set a default destination address for the client that Unisphere CLI (uemcli) is installed on. To view the syntax needed, simply run the following command: uemcli -help

    Additional syntax details for uemcli can be found in the Unisphere CLI User Guide.

  • G

    Gostev

    13 Posts

    1537

    0

    Posted December 26th, 2014 06:00

    Ok. Thanks.

    But even with saving credentials, uemcli will connect to VNXe host for each command?

  • R

    reedic

    28 Posts

    1537

    0

    Posted December 26th, 2014 07:00

    Correct, each command is sent to the VNXe for processing. You can hide the connection response output using the -noHeader flag, which would hide the following lines of output:

    Storage system address:

    Storage system port:

    HTTPS connection

Dell Support Resources

Latest Solutions

View More