Unsolved
This post is more than 5 years old
4 Posts
0
813
November 1st, 2010 12:00
7.2.1 networker client for netware does not list sys vol for recovery
Hi All,
When I use the networkr interface to perform a recovery on my netware server there is no listing for my sys volume. The backups for sys are listed as successfull by the Networker management console. I have another netware server with the same client 7.2.1 and it lists all of its volumes including sys. Any ideas on how I can get networkr to recover my sys volume?
Thanks,
No Events found!
wlee
263 Posts
0
November 1st, 2010 20:00
Is the backup you are looking for still in a browsable state?
If it is not, then this may be the reason why you do not see it in the GUI.
benzino1
2 Intern
•
244 Posts
0
November 2nd, 2010 05:00
Is this a NetWare Cluster environment?
nucleophile
4 Posts
0
November 2nd, 2010 06:00
Yes it is.
Thanks
nucleophile
4 Posts
0
November 2nd, 2010 06:00
No it is not in a cluster.
Thanks
benzino1
2 Intern
•
244 Posts
0
November 2nd, 2010 06:00
Please check how the TSA module is loaded (compare to the other node on which you have not problems) or try to unload it and reload. I have similar problem (but it was cluster environment) and the problem was the TSA module.
nucleophile
4 Posts
0
November 2nd, 2010 07:00
Found my solution. We have issues with our netware backups completeing (hangs after about 90 percent done). We had a series of this issue and tapes labeled recycleable not working. This may have caused issues with the index so that only some of the volumes on that server are visible by the networker client.
Manually performed a full backup on SYS and now can see SYS for recoveries.