Solved!
Go to Solutionlabel multiple tapes in NetWorker 7.2.2
Hello,
On our NetWorker server 7.2.2 and library with bar codes, when we try to label multiple tapes via GUI using the slot range for example 145-148, we get the following message :
The slot names must be in range 145-145. Thus we can only label tapes one by one.
but when using command prompt there no issue with the slot range labeling.
Is it the normal behavior ?
Regards.
On our NetWorker server 7.2.2 and library with bar codes, when we try to label multiple tapes via GUI using the slot range for example 145-148, we get the following message :
The slot names must be in range 145-145. Thus we can only label tapes one by one.
but when using command prompt there no issue with the slot range labeling.
Is it the normal behavior ?
Regards.
- Just select the tape range (by holding shift during
the selection) and then press the label button.
That's not how it works in pre 7.3.x versions (Jeremie said he's at 7.2.2). Having range of tapes defined should work well (the only thing after is to select slow or fast labeling).
IKP1
198 Posts
335
0
Posted November 27th, 2006 07:00
Try going to the tape operations sections again and NOT selecting any tapes or empty /unasigned slots before using the format/label options.
Message was edited by:
IKP