Hi everyone, 

I have configuered MLAG between my two Dell N3048 switches and it's up and running. 

The issue is, i'm using both Ten gigabitethernet ports for the port channel that establishes the peer link, but it's only one interface that's active in port-channel. Is there any limitations on having more than interface in the peer link channel? 

DH-SW01(config)#show interfaces port-channel 10

Channel Ports Ch-Type Hash Type Min-links Local Prf Rx Util Tx Util
------- ----------------------------- -------- --------- --------- --------- --------- ---------
Po10 Active: Te1/0/1 Dynamic 7 1 Disabled 0 0
Inactive: Te1/0/2