I think I may have found a bug: one of my N2000 switches has accounting enabled for dot1x authentication, and configured to send start & stop messages, but I only ever see start messages in the RADIUS server logs, never any stop messages
Can anyone confirm/replicate this?
Here are the relevant lines from the switch configuration:
aaa accounting dot1x default start-stop radius dot1x system-auth-control aaa authentication dot1x default radius aaa authorization network default radius radius server attribute 8 include-in-access-req radius server auth 192.168.0.1 primary name "RADIUS server" key 7 "omitted" exit radius server acct 192.168.0.1 name "RADIUS server" key 7 "omitted" exit
So it turned out that to get the switch to send Accounting stop messages, one has to configure the interface in dot1x MAC-based mode and configure the switchport to general mode (to allow dynamic VLAN assignment).
I think I may have found a bug: one of my N2000 switches has accounting enabled for dot1x authentication, and configured to send start & stop messages, but I only ever see start messages in the RADIUS server logs, never any stop messages
Can anyone confirm/replicate this?
Here are the relevant lines from the switch configuration:
aaa accounting dot1x default start-stop radius dot1x system-auth-control aaa authentication dot1x default radius aaa authorization network default radius radius server attribute 8 include-in-access-req radius server auth 192.168.0.1 primary name "RADIUS server" key 7 "omitted" exit radius server acct 192.168.0.1 name "RADIUS server" key 7 "omitted" exit
JacobDegeling
18 Posts
2172
1
Posted May 8th, 2018 17:00
So it turned out that to get the switch to send Accounting stop messages, one has to configure the interface in dot1x MAC-based mode and configure the switchport to general mode (to allow dynamic VLAN assignment).
.
.
.
interface gi1/0/n
dot1x port-control mac-based
switchport mode general
exit
.
.
.
Thanks Daniel for your help. I hope this helps someone!
Jacob