UNSOLVED

Johnny_Bravo

updated

14 years ago

0

2666

July 7th, 2012 06:00

Data Mover Configuration for DR

Hi Guys,

Just wanted to check that its OK to configure a single data mover on my DR VNX although I have 2 (active / standby) on my primary?

What are the risks/implications of this?

Thanks

JB

  • dynamox

    11 Legend

    •

    20419 Posts

    •

    87439 Points

    2043

    0

    Posted July 7th, 2012 06:00

    are you running out of supported capacity on one datamover and you wanted to use another one as an active one ?

  • dynamox

    11 Legend

    •

    20419 Posts

    •

    87439 Points

    2043

    0

    Posted July 7th, 2012 06:00

    it's ok but if you need to do maintenance on the DR unit or it completely goes out, with one datamover your replication will grind to a halt because it will have no where to failover to.

  • 2043

    0

    Posted July 7th, 2012 06:00

    Good point dynamox - in view of that its probably a safer bet to use two at DR for what they cost.

    Thanks for the rapid response!

  • 2043

    0

    Posted July 7th, 2012 08:00

    No just a design consideration question, thats all.

    Would the same apply for control station at the DR site. Ie - using 2?

    Thanks

  • dynamox

    11 Legend

    •

    20419 Posts

    •

    87439 Points

    2043

    0

    Posted July 7th, 2012 09:00

    if you have one control station and it's not available, you can't manage the system but as far as datamover functionality is concerned ..it keeps on chugging along.

  • 2043

    0

    Posted July 7th, 2012 09:00

    Thanks dynamox - That much I do know but what I'm not sure on is if anything would happen to replication if my CS at the DR site went offline?

  • Rainer_EMC

    6 Operator

    •

    8645 Posts

    2043

    0

    Posted July 10th, 2012 05:00

    It will but you cant manage it and some operations like file system extension might not work

  • dynamox

    11 Legend

    •

    20419 Posts

    •

    87439 Points

    2043

    0

    Posted July 10th, 2012 05:00

    i believe once replication is configured, you can take CS offline and replication will keep on going.