Start a Conversation
UNSOLVED

bionicstas

updated

16 years ago

B

bionicstas

3 Posts

0

1001

November 16th, 2010 17:00

Equallogic 6000e vSphere 4.1 iSCSI config?

Hi All,

I have a VM configured with 2 ports as Iscsi and configured as per recommendations, the VM connects to EQ 5000e and it shows as Multipath Ie 2 connections to the EQ from VM, connected as seperate IP's.
I also have a news set up Dell R710 server with EQ 6000e and same setup as above, however I can not get it to connect with both ports.
Also when I pull the cord out it does not switch over to the other port. ie I lose connection

EQ 5000e, running ver 4.36 and is installed on Dell 2950, Vsphere 4.1
New setup
EQ 6000e, running ver 5.02 and is installed on Dell R710, Vsphere 4.1

Any Ideas?

Regards
  • B

    bionicstas

    3 Posts

    268

    0

    Posted November 16th, 2010 20:00

    "Hi All,

    I have a VM configured with 2 ports as Iscsi and configured as per recommendations, the VM connects to EQ 5000e and it shows as Multipath Ie 2 connections to the EQ from VM, connected as seperate IP's.
    I also have a news set up Dell R710 server with EQ 6000e and same setup as above, however I can not get it to connect with both ports.
    Also when I pull the cord out it does not switch over to the other port. ie I lose connection

    EQ 5000e, running ver 4.36 and is installed on Dell 2950, Vsphere 4.1
    New setup
    EQ 6000e, running ver 5.02 and is installed on Dell R710, Vsphere 4.1

    Any Ideas?

    Regards"
    Hi All,

    Found that I have missed a step and did not bind the ports to the vhmba.
    All is functioning as it should be.

    Regards

Dell Support Resources

Latest Solutions

View More