The errors I'm seeing on the server have changed a bit from the original (ie 0:00:0).  Can you shed on light on this?  I appreciate your help.  Thanks.

 

1-07-2008  10:49:04 am:    PERC2-2.70-0
   Severity = 0
   ID(0:00:0); Error Event [command:0x28]

1-07-2008  10:49:04 am:    PERC2-2.70-0
   Severity = 0
   ID(0:00:0); Medium Error [k:0x3,c:0x11,q:0x2]

1-07-2008  10:49:04 am:    PERC2-2.70-0
   Severity = 0
   ID(0:00:0); Error Too Long To Correct

1-07-2008  10:49:06 am:    PERC2-2.70-0
   Severity = 0
   Container 0 failed REBUILD task: I/O error - drive 0:0:0

1-07-2008  10:49:06 am:    PERC2-2.70-0
   Severity = 0
    failed

I have seen sometimes where you can get away with not rebooting, however if you cannot access the Storage section you may have to.

I just installed Dell OpenManage Systems Management on the server.  The installation appears to have gone OK but I'm being prompted to restart the server.  I'm afraid to do that and then the server not come back up.  Any suggestions?  Thanks!

eberrocal,

 

It looks as if Drive 0:02:0 has media errors and has failed.  It is trying to rebuild the drive which is why they are blinking green.  But the rebuild is failing because of an I/O error with drive 0.  The media errors may have been written to drive 0 as well.  I would start with getting a new drive in for drive 2 and see if the rebuild completes.  I am not familiar with Novell, but I would schedule a disk check after/if the rebuild completes.