Hi,

These are the upgrades for the PowerEdge 2400 (58V110B) as shipped.

System BIOS, PowerEdge 2400, A09
FileName:  PE2400-BIOSA09.exe [513 KB]
Release Date:  5/22/2003
http://support.dell.com/FileLib/Format.aspx?ReleaseID=R56380

Dell ESM Firmware, Multi-System, A51
Filename: a51cust.exe (405 KB)
http://support.dell.com/filelib/format.aspx?ReleaseID=R27673
Note: Extract the files to a DOS bootable floppy disk. Boot the server to this floppy disk, and run smflsh.exe.

Adaptec PERC2/Si, Firmware, PowerEdge 2400, v. 2.7.1.3571, A09
Filename: BI357109.exe [911 KB]
http://support.dell.com/filelib/format.aspx?ReleaseID=R46835

Press F6 when prompted by the Win2000 installation to load this driver:

PERC2, 2/Si, 3/Si, 3/Di, Driver, 2000, v. 2.7.1.4944, A12
Filename: w2ka12dr.exe [211 KB]
http://support.dell.com/filelib/format.aspx?ReleaseID=R47959

Hi

Mark thanks every thing work

Same problem here. Service Tag 89HV801. Really concerned about the PERC card. What drivers do I need Mark?

Hi Michael,

This PowerEdge 2400 had a Perc 2/dc factory installed. These are the latest firmware and driver upgrades for this configuration:

System BIOS

ESM Firmware

Win2000 Perc 2/dc upgrades

Thanks for using the Dell Community Forums!

Thanks Mark,

One quick question: The system Bios you point me too says not to use unless you are upgrading to Windows 2003. I am only upgrading to Windows 2000. Do I need a different Bios version?

Thanks again.

Hi Michael,

The documentation of that System BIOS download is a little unclear. It should say that support for Windows Server 2003 was added, not only. It will work fine on your system with Win2000.

I apologize for the confusion.

Thanks
Mark