UNSOLVED
U
UncleChuck
8 Posts
0
23019
January 26th, 2006 23:00
Blue Screen Stop message # 0x0000007b. Help!!
I have a Dimension E310 with two 160GB Hard drives in a RAID 1 (mirrored) configuration. I changed to a non-RAID configuration, thanks to help from Bev "shesagordie". Everything seemed to be ok (I ended up with two hard drives with the same data on each). I then reformated the second hard drive, and after that every time I reboot (even into safe mode) I get the Blue screen Stop message # 0x0000007b with instructions to do a chkdsk. This occures immediately after mup.sys trys to load. I did a chkdsk and everything seemed to be ok except the chkdsk message stated that one or more errors had been corrected. I still can't get past the Blue Screen Stop 7b message.
I am hoping I won't have to reformat and reinstall everything. Can anyone make a suggestion how to correct this problem?
UncleChuck
UncleChuck
8 Posts
1096
0
Posted January 27th, 2006 22:00
I did a diagnostic test on the second hard drive today, and It passed on everything.
I had formated the hard drive using the format option in Windows Explorer. I did not install any software.
Any more suggestions would be welcomed.
UncleChuck
shesagordie
12 Elder
•
46017 Posts
1096
0
Posted January 28th, 2006 00:00
UncleChuck
What is the full text of the error message?
Bev.
UncleChuck
8 Posts
1096
0
Posted January 28th, 2006 05:00
The full text is:
A problem has been detected and windows has been shut down to prevent damage to your computer.
If this is the first time you've seen this stop error screen, restart your computer. If this screen appears again, folow these steps:
Check for viruses on your computer. Remove any newly installed hard drives or hard drive controllers. Check your hard drive to make sure it is properly configured and terminated. Run CHKDSK /F to check for hard drive corruption, and then restart your computer.
Technical information:
*** STOP: 0x0000007B (0xF79D9524, 0xC0000034, 0x00000000, 0X00000000)
UncleChuck
UncleChuck
8 Posts
1096
0
Posted January 28th, 2006 16:00
I receive the error message when I am booting up.
I used Windows explorer to format the secondary hard drive.
UncleChuck
shesagordie
12 Elder
•
46017 Posts
1096
0
Posted January 28th, 2006 16:00
UncleChuckOn which hard drive [primary or secondary] to receive the error message?Did you use XP disk management to format and partition the second hard drive?Bev.shesagordie
12 Elder
•
46017 Posts
1096
0
Posted January 28th, 2006 17:00
UncleChuck
Try using the Last Known Good Configuration Feature in Windows XP,
Bev.
UncleChuck
8 Posts
1096
0
Posted January 28th, 2006 20:00
I already tried that unsuccessfully.
UncleChuck
- same problem here have a M90 want to install xpro(original buy no oem) en getting the same blue screen over and over again
0x0000007B
im sick of vista buisness64 if anywone can help me please do.
have used sata drivers, the f6 solutions nothing helps no option in the bios to turn of the sata ....
Anywone from dell or somwone other help.
shesagordie
12 Elder
•
46017 Posts
1096
0
Posted January 27th, 2006 02:00