2135 Scan to network

Sorry, seems what I put in next didnt come out properly.

 

Here is the configuration I have:

Name  Lees Scan  

 

Server Type SMB 

 

Server Address  192.168.etc...

 

Share Name  Scanned Documents

 

Server Path  office.powerfulpoints.com.au\D:\XXXX\Scan Output

 

Server Port Number 139

did you get this problem sorted in the end?

 

I am having the same issue and its resisting all solutions thus far.

 

Jim.

 

Update, just found that there is a firmware update released on 8/22/2014 for this, 5 days ago. So I will try that and report back.

There was no mention of SMB in the "Fixes and Enhancements".

We are having this issue on a Dell 2665.

However, the original poster has a Server Name, Share Name, Server Path that seems odd to me.

Not sure why in his server path, there is a FQ Hostname, AND a drive letter and colon.

My server destination is:
\\server1\share1\folder1

Which in the Address Book is:
Server name: server1
Share Name: share1
Server Path: folder1

(note: where server1, share1, folder1 are generalized for this forum)

It works fine when the printer is first booted up. and will work for several minutes. However, after about 15 minutes, when it enters "Deep Power Save" mode, when we wake it up, we get 031-530. If we reboot the printer, it works again. Interestingly, when we print to it, when it's in deep power save mode, it does wake up and print, just won't scan until rebooted.

One thing possibly unique, is we have two of these Dell 2665 multifunction printers on our network, and they are both setup with a different TCP/IP hostname, and SMB hostname. RM12665, RM22665 respectively.

Any reflections/suggestions?