This post is more than 5 years old
3 Posts
0
12177
Powerconnect 35xx management VLAN
Is possible to set VLAN different from VLAN 1 as management VLAN on Powerconnect 35xx? I can't try it at the moment as I don't have the hardware.
I suppose this configuration:
console(config)#interface vlan 10
console(config-if)# ip address 192.168.10.123 255.255.255.0
Can someone who did it in reality confirm that it works?
Thanks.
Anonymous
5 Practitioner
5 Practitioner
•
274.2K Posts
0
November 11th, 2013 06:00
On most PowerConenct switches you would actually change the management VLAN using this command.
console(config)#ip address vlan 10
However the 35xx switches don’t have this command. The commands you outlined will assign an IP address to VLAN 10, and you should be able to use that IP address to access the web GUI to manage the switch.
miroslavp
3 Posts
0
November 11th, 2013 13:00
Hi Daniel,
Thanks for your reply.
Just for clarification... If I assign IP address to VLAN 10, I will be able to access the GUI through this address even though I can't use "ip address vlan 10" command? Right?
Can I access web GUI only or it works for Telnet/SSH/FTP etc. too?
Many thanks
vwijhe
35 Posts
0
November 12th, 2013 03:00
miroslavp
3 Posts
0
November 12th, 2013 04:00
OK, thank you.
Anonymous
5 Practitioner
5 Practitioner
•
274.2K Posts
0
November 12th, 2013 05:00
Correct, you will be able to Telnet, SSH to that IP address as well.