Unsolved
This post is more than 5 years old
2 Posts
0
2813
S4048 selective qinq
Hi
I cannot find for the life of me if the S4048 with the Dell OS supports selective QinQ?
About to purchase 8 of these units, but it has to support selective qinq.
Thanks
mark_m_fisher
1 Message
0
March 8th, 2018 08:00
Hello Paulmcm,
Have you taken a look at Chapter 49 (Service Provider Bridging) that begins on page 855 of the Dell "Configuration Guide for the S4048-ON System 9.13.0.0" where it covers the topic of "Service provider bridging provides the ability to add a second VLAN ID tag in an Ethernet frame and is referred to as VLAN stacking in the Dell EMC Networking OS.?
The document can be found at the following link:
http://downloads.dell.com/manuals/all-products/esuprt_ser_stor_net/esuprt_networking/esuprt_net_fxd_prt_swtchs/force10-s4048-on_white-papers1_en-us.pdf
Regards,
Mark
DELL-Josh Cr
Moderator
Moderator
•
8.5K Posts
0
March 8th, 2018 08:00
Hi,
It is called VLAN stacking on these switches. Page 1711 shows the command, see if it does what you need. http://downloads.dell.com/manuals/all-products/esuprt_ser_stor_net/esuprt_networking/esuprt_net_fxd_prt_swtchs/force10-s4048-on_administrator%20guide3_en-us.pdf
Paulmcm
2 Posts
0
March 8th, 2018 11:00
It is a bit vague, I must admit even from looking through the manuals.
Selective qinq can identify the inner VLAN tag of the packets according to the MAC address, IP protocol, source IP address and VLAN tag, then determine which tag should be added. - This is what I want to do - cannot see an example or reference to it.
DELL-Josh Cr
Moderator
Moderator
•
8.5K Posts
0
March 9th, 2018 06:00
I do not see a way to do this with this switch.