Unsolved
This post is more than 5 years old
76 Posts
0
2168
The configuration server can't obtain the necessary resources to perform the requested service
Can't remove a device from a host:
# symmaskdb list assignment -dev 005F
Symmetrix ID : xxxxxxxxxxx28
Device Identifier Type Dir:P
------ ---------------- ----- ----------------
005F 10000000c96b7e91 FIBRE FA-8D:1
10000000c96d57ae FIBRE FA-8D:1
10000000c96d5ac9 FIBRE FA-8D:1
10000000c96749e7 FIBRE FA-8D:1
10000000c96d5a88 FIBRE FA-8D:1
10000000c9965040 FIBRE FA-8D:1
10000000c96b7c33 FIBRE FA-9D:1
10000000c96d58a1 FIBRE FA-9D:1
10000000c96d596e FIBRE FA-9D:1
10000000c96d5897 FIBRE FA-9D:1
10000000c96346d8 FIBRE FA-9D:1
10000000c9964f10 FIBRE FA-9D:1
# symconfigure -sid 28 -cmd "unmap dev 005F from dir 8D:1;" commit
Establishing a configuration change session...............Established.
Processing symmetrix xxxxxxxxxxxxx28
Performing Access checks..................................Allowed.
Checking Device Reservations..............................Allowed.
Submitting configuration changes..........................Submitted
Locking devices...........................................Locked.
Validating configuration changes..........................Validated.
Initiating PREPARE of configuration changes...............Prepared.
Initiating COMMIT of configuration changes................Queued.
COMMIT requesting required resources......................Timed out.
Error occurred while Committing
The configuration server can't obtain the necessary resources to perform the requested service
Closing configuration change request......................Closed.
Terminating the configuration change session..............Done.
The configuration change session has failed
??
Fenglin1
2 Intern
2 Intern
•
2.1K Posts
0
July 11th, 2012 23:00
regarding emc253282, it might be some script running in your box. can you just wait some time and try again?
if same, you can refer Saurabh's suggestion.
sauravrohilla
859 Posts
0
July 11th, 2012 23:00
Hi,
Most likely your Service processor is hung and needs a reboot or there is a failed script on the Symm?
regards,
Saurabh
satheeshnp
11 Posts
0
July 13th, 2012 07:00
You can wait foe few minutes and you can try. It will work
I also faced the same issue because EMC Engineer was working on SP. After few minutes COmit operation was working fine.