Start a Conversation

Unsolved

This post is more than 5 years old

1118

December 15th, 2013 19:00

nsrndmp_recover spawn and stream limitation

Hi All

Realizing that during NDMP recover, more than one nsrndmp_recover process spawned. (backed up using DSA method)

There are 4 streams limitation (cant increase, physical limitation). Day time 3 backup sessions active. Expected to use 1 for restore.

Any way to limit the number of spawn so that these message not thrown and halts/aborts restore?

42619:nsrndmp_recover: NDMP Service Error: Active NDMP backup/restore streams reach the maximum concurrent streams supported 4 (at the moment only 3 is active). No more NDMP sessions can be started. Wait current backup/restore sessions finish before start new ones.

42597:nsrndmp_recover: data connect: failed to establish connection

42849:nsrndmp_recover: Unable to start the NDMP restore process.

EMC VNX Celera

Networker 7.6.3

Thank you

2 Intern

 • 

14.3K Posts

December 16th, 2013 01:00

To me this sounds as setting on Celerra itself (check Celerra backup guide).  This can be changed away from default 4 per data mover, but depends on configuration of Celerra DM and not just wishes - support should check if this is recommended in your case or not. 

2 Intern

 • 

326 Posts

December 18th, 2013 13:00

Hi Hrvoje

There are 4 streams limitation (cant increase, physical limitation).


The software is spawning more than one process so wondering if can limit that

2 Intern

 • 

14.3K Posts

December 18th, 2013 14:00

Thierry,

How did you configure it in the first place?  I had, for example, 400 shares and I used 2 streams - no issues there.  I could have used 4 where I would hit default limit of dm.  If you wish to change that, talk to support. If you wish to limit number of session created by NSR towards ndmpd, use client parallelism.

No Events found!

Top