Unsolved
This post is more than 5 years old
119 Posts
0
1225
Connection parameter on VNX
Hello,
Please let me know how can I set below two parameters on our VNX 5500;
ExternalConnectionLimit
ExternalConnectionLimitPerHost
Thanks,
Unsolved
This post is more than 5 years old
119 Posts
0
1225
Hello,
Please let me know how can I set below two parameters on our VNX 5500;
ExternalConnectionLimit
ExternalConnectionLimitPerHost
Thanks,
Top
Rainer_EMC
8.6K Posts
0
June 17th, 2015 11:00
No idea what these are – they dont look like data mover parameters
jithin
91 Posts
0
June 19th, 2015 02:00
I referred the parameter guide for VNX, but couldn't find any such parameters. You can list the facilities and server parameters for each facilities using command line.
Please refer the Parameters Guide for VNX for File for more details.
Jithin
kelleg
4.5K Posts
0
June 19th, 2015 14:00
I think you may be looking for how many hosts you can connect to the array. The number of hosts is based on the number of HBA's that each SP port or SP or array can support.
glen
SunshineM
119 Posts
0
June 22nd, 2015 05:00
Thanks for the reply. I have had EMC dispatch engineer to location to connect to SP physically and change those parameters.
Thing is also do not know if it is related to above table that you posted, because was not able to connect via "Set RemotelyAnywhere Access Restrictions > Giving IP of local desktop from where I connected setup page of one of the SP"
Will update you once done at location.
kelleg
4.5K Posts
0
June 22nd, 2015 09:00
Are you referring to the Management Ports on the array - the IP addresses for SPA and SPB? If so, I don't believe there is a connection limit (the number of external users connecting to the SP ports), but if you're referring to logging into the array to use Unisphere, then there is a limit, but I can't remember what that is - I'm thinking that only one user is allowed to be logged into Unisphere at one time.
Are you asking about the FILE side of the array - the Celerra side or just the block side?
glen