This post is more than 5 years old
3 Posts
0
5859
Provisioning Unitity Storage from VPLEX GUI
Hi all,
what is needed to control storage resources from VPLEX GUI? We have an Unitity System and we want to managed the provisioning from VPLEX GUI. So you have just one instance.
For VNX and VMAX Arrays you must install the Solution Enabler with SMI-S Provider. Since Version 8.0 (Solution Enabler) the Support is just for VMAX.
Which Settings are Software is needed to provisioned storage from VPLEX?
Thanks,
Chris
SteveK821
2 Intern
2 Intern
•
141 Posts
0
March 6th, 2018 00:00
If you have 2 unity systems, with one on each site, you should only add one unity to each cluster.
The error message is quite common. Just restart the management service on each cluster. See this KB.
502814 : VPLEX: VIAS operations that require cross-cluster communication fail https://support.emc.com/kb/502814
Log out of all GUI sessions, then log in to each cluster via SSH (but do not go into VPLEXCLI) and run:
sudo /etc/init.d/VPlexManagementConsole restart
Wait a few minutes before logging back in to the GUI
SteveK821
2 Intern
2 Intern
•
141 Posts
1
November 17th, 2017 01:00
Minimum VPLEX Code Version is 6.0 for supporting Unity with VIAS (and 6.0 SP4 is highly recommended).
You need to add the Unity directly as SMI-S. Just enter the Management IP Address of the Unity array and use SSL (port 5989, I think). Enter the login details for Unity, and then it will be added as a Managed Array. You don't need any external SMI-S provider or Solutions Enabler.
sohnch
3 Posts
0
March 5th, 2018 06:00
Hi,
thanks for your answer.
we can added the storage-systems only on one Cluster:
We have two unity-Systems, one on each site, when I open the VPlex-Gui and add this two Systems on one Cluster... no Problem. If I try to connect the same storage-systems on the other Cluster (cluster-2), then I get the Error:
Failed to register array management provider. Unreachable remote system 'clsuter-2'.
When I Login to the clsuter-2-GUI I have the same problem with storge for Cluster-1.
We want to take provisioning of distributed storage.
Thanks...
sohnch
3 Posts
0
March 6th, 2018 02:00
Hi,
many thanks... now it works.
Last question: How can you delete a array-System from the AMP? I unregister the System but I can't delete them.
regards,
Chris
wanaka
1 Rookie
1 Rookie
•
116 Posts
0
June 10th, 2019 22:00