Unsolved
This post is more than 5 years old
3 Posts
0
4677
Unity 300F register initiator manualy
Hi
I am configuring a UNITY 300 with the brand new interface. I am looking for a way to register some initiators not registered.
It should do it automaticaly however in my case, the second one is not .
I can't find a way to do this in the interface
Equelin
20 Posts
0
July 7th, 2016 00:00
Hello,
Could you please provide more informations:
- What kind of Initiators would you like to register ? (FC, iSCSI).
- Did you add your host manually or automatically (via a vCenter, for example)?
Please note that you can add initiators to a manually created host through Unisphere:
- Go to Unisphere > Access > Host
- edit the host properties
- Go to Initiators tab
- Click on the + icon
- Add your initiator
By the way, before trying to add manually a initiator I will try to understand why it does not register automatically. If it's a FC initiator, you could look at your zoning for example.
Regards,
phennart
3 Posts
0
July 7th, 2016 06:00
THanks for reply
it was FC initiator , they were showned in the console but not registred.
eventualy it was a zoning issue.
rgds
Equelin
20 Posts
0
July 8th, 2016 02:00
Hello,
Should I understand that it's working now ? I'm glad to hear it.
Regards,
Girinadha
1 Message
0
July 14th, 2017 03:00
Hello,
We are using EMC unity300 ( version 4.0.2.8627717)
We have similar issue in my environment, We have checked zoning and Host initiators connectivity.
Zoning is perfect and host initiator connected on SAN switch. But when we are trying to register host on storage initiators are not visible automatically. Manually we have resisted and allocated LUNs to host ( but not visible at host level)
In some cases we have observed that initiators visible at storage console after 48 hrs. is there any solution for the same??