This post is more than 5 years old
7 Posts
0
3244
Isilon Gen6 Frontend Connectivity
Hi All,
IHAC who wants to connect some Nodes of a Gen6 Cluster (A200) on a 1GbE Switch. Is this possible/supported? Are the 10G Frontend Interfaces are 1GbE enabled?
many thanks for hints..
regards uwe
Phil.Lam
3 Apprentice
3 Apprentice
•
592 Posts
0
June 4th, 2018 11:00
UweNaumann
No, the NICs on Isilon are not auto-sensing.
DevinLucas
16 Posts
0
June 1st, 2018 07:00
Gen6 A200 nodes all have a single 1Ge port in addition to two 10GigE ports. Just plumb those up, you don't need to use the 10Gig ports.
UdoHase
7 Posts
0
June 1st, 2018 09:00
yes i know about the 1GbE Interfaces on Gen6 Nodes.... But the main question was, if it is possible to connect the 10GbE ports on the A400 Nodes on 1GbE Switchports?
regards Uwe
philippspohr
1 Rookie
1 Rookie
•
107 Posts
0
June 4th, 2018 01:00
But keep in mind that you don't have LACP with only one network connection. The 1Gb port is normally used for management.
UdoHase
7 Posts
0
June 4th, 2018 23:00
thanks for all responds...
regards uwe