Unsolved
41 Posts
0
1530
Trunk between CAT93k and Dell 6200 Help !!!
Hello i have a configured a trunk port between a Cisco and a DELL powerconnect however i cannot pass traffic
the Blue is CISCO
the Orange is DELL
What did i misconfigure? Native VLAN is 20 for DATA
DELL-Josh Cr
Moderator
Moderator
•
8.7K Posts
0
June 27th, 2019 10:00
Hi,
Since the Cisco is in trunk mode it should be sending tagged packets, but the powerconnect is sending back untagged traffic and it doesn’t know what to do with them. Try setting the power connect to send VLAN 20 as tagged.
nflnetwork29
41 Posts
0
June 27th, 2019 11:00
hi josh,
still not passing traffic.
if i put both sides into switchport access vlan 20 i can pass the vlan 20 traffic.
its just in trunk and general mode i cannot pass anything .
DELLconsole#show running-config interface ethernet 2/g17
description "Uplinkto9300'"
mtu 9216
switchport mode general
switchport general pvid 20
switchport general allowed vlan add 7,10,20 tagged
switchport general allowed vlan remove 1
CISCO
Building configuration...
Current configuration : 154 bytes
!
interface GigabitEthernet1/0/1
description UplinkDELL
switchport trunk native vlan 20
switchport trunk allowed vlan 7,10
switchport mode trunk
end
DELL-Josh Cr
Moderator
Moderator
•
8.7K Posts
0
June 27th, 2019 13:00
What happens if you make both sides trunk ports?
nflnetwork29
41 Posts
0
June 27th, 2019 14:00
how do i configure the native vlan when using a trunk port?
DELL-Josh Cr
Moderator
Moderator
•
8.7K Posts
0
June 27th, 2019 15:00
Trunk ports don’t have a native VLAN. Why do you need an untagged VLAN between the switches?
nflnetwork29
41 Posts
0
June 27th, 2019 17:00
vlan 20 is not tagged its just the defaut vlan for the data lan
we do not use vlan 1
DELL-Josh Cr
Moderator
Moderator
•
8.7K Posts
0
June 28th, 2019 07:00
Ok, everything else looks fine from the current configuration so it should work. Is the firmware up to date?
nflnetwork29
41 Posts
0
June 28th, 2019 08:00
i dont think so
current F/W = 3.3.17.1
can you suggest a latest stable version to upgrade to?
DELL-Josh Cr
Moderator
Moderator
•
8.7K Posts
0
June 28th, 2019 09:00
Not that far out of date, but here is the latest. https://www.dell.com/support/home/us/en/04/drivers/driversdetails?driverid=xtj1x&oscode=naa&productcode=powerconnect-6248
nflnetwork29
41 Posts
0
July 9th, 2019 11:00
do i need to enable routing on my VLAN? (on the dell switch)
will this cause any interruption if i change it?
DELL-Josh Cr
Moderator
Moderator
•
8.7K Posts
0
July 10th, 2019 08:00
It shouldn’t cause any interruption.