No – that shouldn’t happen and I’ve never seen it

Please open a service request so that support can properly troubleshoot

That should never happen.  What output did you see from "server_cifs" when the the server was missing?

No, l didn´t see a failover, but the uptime of both datamovers started at 0:00.

Was there something like fastboot on the dm, so that the connection don´t get lost while a rebbot.
I did the reboot in the GUI not by CLI

Agreeded.  Did it Failover to the standby datamover?

On every system the connection gets dropped when it is rebooted – that is the way TCP/IP works

The client is supposed to re-initiate that connection when the server is available again.

How that looks like to the client depends on the Windows version, the application and what you are doing while the connection isn there

Hi Mark,

the output of the cli showed that the server exists, but the hosts lost the connection to the shares.

´Then I added the CIFS server in the GUI witout joining the domain, and after that it worked again.

I have never seen this before and have no idea what can cause this.

So I will open a case at emc.

That sounds differently than the CIFS server being deleted after a reboot ….

Yeah,  this sound like normal windows behavior... Windows is stateful,  so it will not be happy during reboot - a lot of windows versions don't do this very well..  I suspect reconnecting drives or rebooting the hosts in question would also solve the issue..

This is one the benefits we find using Isilon over celerra... the Windows hosts don't notice...

sure they do, if you are using static smartconnect pool where IP do not failover like they do in dynamic pool ..clients get disconnected.

There is no fundamental difference there between VNX and Isilon or other CIFS servers

If the CIFS server reboots or fails over the TCP connection gets dropped as does the SMB session

Both have to be re-established by the client

Whether or not you notice that on client doesn’t change the way it works

What is there difference there with Isilon ?

The way the VNX data mover failover works with always transferring the IP address on failover makes it actually easier on the client than having to look for a new IP

With SMB3 CA it is even better