Start a Conversation
UNSOLVED

philsid

updated

15 years ago

P

philsid

8 Posts

0

16705

May 11th, 2011 23:00

Failed PE driver import into SCCM

Hi There,
Is anyone else seeing failures importing the WinPE drivers into SCCM? I'm getting the error 'the selected driver is not applicable to any platforms' for a number of drivers including:
- x64\network\R235484\E1Y62x64.inf
- x64\network\R267025\E1K62x64.inf
- Any other network drivers in the PE package, either x86 or x64

Is anyone else seeing this or is it just me?
  • DW

    DELL-Warren B

    1 Rookie

    •

    1124 Posts

    471

    0

    Posted May 19th, 2011 14:00

    I haven't seen it, but I know that an occasional DOS driver will be in the NIC drivers and can cause an Import to fail with that error. There is a Microsoft Patch for ConfigMgr which addresses drivers that are only targeted to Windows 7 which cause the same error to occur.
  • P

    philsid

    8 Posts

    471

    0

    Posted June 1st, 2011 22:00

    Thanks for the reply Warren. We installed the following hotfix from Microsoft for ConfigMgr 2007 SP2 and it resolved the issue, in case anyone else found the same issue.
    http://support.microsoft.com/kb/978754
  • B

    brs90210

    1 Message

    471

    0

    Posted September 14th, 2011 14:00

    Philsid, thanks for the post for the hotfix. I had the same issue with PE drivers and 6410 & 6420 drivers and was going nuts. The hotfix corrected it all. Thanks for sharing

Dell Support Resources

Latest Solutions

View More