rickboo

updated

17 years ago

R

rickboo

16 Posts

0

1045

November 21st, 2009 10:00

Adding memory

I am still a little confused confused about adding memory to my dell dimension e520. Currently it has  512mb for memory ,2 256mb modules in slots 1 and 2. I want to bump it up to 1gb. I live in canada so i want to save on shipping and duty. M y question is, would it be best to just purchase 2 more 256 modules or can i purchase 1- 512 module and add it? The 512 is cheaper than the 2-256 modules. If i can just add the 512 module then which slot would i put it in and which slots would i move the 256 modules to. If i go with all 256 modules and i decide later to increase the memory more then it would have been a waste of money buying 2 more 256 modules. I would appreciate if someone could give me some advice or thoughts. Thanks a bunch

  • Thereal-dbk4297

    4 Apprentice

    •

    3351 Posts

    150

    1

    Posted November 21st, 2009 11:00

    Hello,

    Look on page 69 of this support PDF file for your E520. You can also look at the specs section for memory.

    But, It is best to install matched pairs of the correct memory so that the system can get a speed boost using dual data rate. So, if you just need a total of 1 GB of memory check which cost less. Two matched sets of the "correct" memory at 256MB to add to your old, or two 512MB chips?

    You must be made aware that Dell systems are very picky with memory upgrades. You can read out the issues at the memory pages of my web site.

  • rickboo

    16 Posts

    150

    0

    Posted November 21st, 2009 11:00

    Hello, thank you much for the reply and the info. I checked out the manual and saved it for future reference. I also checked out your site and also the instructions on the crucial site. I guess i will go with the 256 modules. That should be more than enough for what i do. Thanks again for the reply. Greatly appreciated