UNSOLVED
Error Code 654C:041C
Dimension 9150 will not boot. Finishes raid utility boot and locks up. I ran the Dell utilities cd and get the following errors.
Error Code 654C:041C Channel 2 is not functioning correctly.
Message Edited by jcmcmahon on 01-06-200707:54 PM
- Jcmcmahon, is the system emitting any beep error codes or is the diagnostic lights giving an error code which could help pin point the problem? You can click here for an explanation of those error codes from your model's on-line Service Manual.
- I get the code when I run the Dell diagnostic utility. The machine boots up fine, steps through the raid config, and then will not load the operating system. Screen goes black, and stays black.I have been on the phone with Dell techs, 4 different ones, they all want me to reload Windows, but I beleive it is the motherboard or processor. I don't want to nuke all data until I'm sure it is not hardware.
- Exact same prob here, look like others solved it with the XP CD recovery tool.
My thanks go to dell for supplying a nice card in the box instead of the CD.
Anyone come to a solution with this?
From what I have read tonight, its a XP SP2 vs. motherboard issue.
When I try to boot in safe mode...its halts at MUP.sys, so I cant even get to regedit or msconfig (or don't know how). - Quyonmob, click here for a forum search on the mup.sys problem. There are quite a few postings related to that problem and I would suggest reviewing them to see how other folks resolved it.
mombodog
2 Intern
•
12735 Posts
289
0
Posted January 7th, 2007 02:00