Solved!
Go to SolutionO
obermudez1
27 Posts
0
1355
November 16th, 2010 12:00
Tape backup problem with giant files
I have trouble completing backups of very large files 890 GB - 1.2 TB.
The files are in Clariion, the file system is Ext3, are exported to a StorageNode with Centos OS 4.5
The backup to tape (LTO3) starts normally, but when you have completed approximately 147 GB backup is interrupted due to inactivity.
I think it has to do with the file system, but not that setear parameters. If I do the backing of a local disk is no problem, I have files similar in size to another server with xfs filesystems and gives errors in the backup.
I appreciate your answers.
Polska1422
2 Intern
•
128 Posts
675
0
Posted November 17th, 2010 04:00
Hi Orlando,
Are you using Networker 7.6 or 7.6.1? These are the only versions that can support CentOS.
Regards
Claudio
Polska1422
2 Intern
•
128 Posts
675
0
Posted November 17th, 2010 05:00
Hi Orlando,
OK, but you'll keep on mind that NW versions older than 7.6 cannot support CentOS O.S. If you need to open a service request with EMC, first upgrade the NW version.
Regards.
Claudio
obermudez1
27 Posts
675
0
Posted November 17th, 2010 05:00
Hi Claudio,
first of all thanks for replying, my server is solaris 9 with NetWorker 7.4.2 and Client CentOs 4.5 with NetWorker 7.5
My doubt is because I have another StorageNode with Suse and had the same problem and I solved it by updating the NfsClient package on the client, did the same at the CentOs but not resolved.
I thought there was no problem with the version of NetWorker because the installation was no problem, and backups of local disks with the same files (1.2 TB) was successful.obermudez1
27 Posts
675
0
Posted November 17th, 2010 08:00
Hi Claudio,
Make the changes proposed by Mr. Arum Daniel and apparently is paying off. Before the backup did not exceed the 147 GB are now 578 Gb file. As have the results I will be advising whether the solution used was effective.
Thanks again for your support.
obermudez1
27 Posts
675
0
Posted November 17th, 2010 10:00
Hi, Daniel
Excellent reply, perform the tests solicitastes and backup completed successfully.
Very grateful for the support, it solved the problem.
Greetings.
Daniea3
123 Posts
675
0
Posted November 17th, 2010 02:00
Hi Orlando,
In your case the first thing I would suggest is to change the Inactivity Timeout value on the Group properties to zero. Test a backup and if it fails again with the same error then follow the procedure mentioned in below KB to set NSR_KEEP_ALIVE.
http://solutions.emc.com/EMCSolutionView.asp?id=esg91994&usertype=C
Regards,
Arun