The 'show ip mroute' command is a basic multicast troubleshooting command to display the full contents of the IP multicast routing table. This command is used in troubleshooting to verify:

• The (S,G) and (*,G) state entries from the flags.

• The incoming interface is correct.

• The outgoing interface(s) is correct or if it is incorrectly pruned.

The 'show ip mroute' command appears to be missing from OS10.  Is there an alternative syntax to display the full contents of the multicast routing table?

S4148T-ON11# show ip mroute
% Error: Unrecognized command.

S4148T-ON11# show version
Dell EMC Networking OS10 Enterprise
Copyright (c) 1999-2021 by Dell Inc. All Rights Reserved.
OS Version: 10.5.2.3
Build Version: 10.5.2.3.316
Build Time: 2021-02-26T20:03:25+0000
System Type: S4148T-ON
Architecture: x86_64

Thanks in advance!