Hello,

did you check this documentation, it can be helpful?

Removed by Moderator

Thanks

Hi Marco, many thanks for your suggestion.

Unfortunately, that document is for OS 9. If I attempt to do this on OS 10, I don't have an interface "spanning-tree portfast" option:

switch# configure terminal
switch(config)# interface ethernet 1/1/10
switch(conf-if-eth1/1/10)# spanning-tree portfast
% Error: Illegal parameter.

switch(conf-if-eth1/1/10)# spanning-tree ?

  bpdufilter  BPDU filter on the interface
  bpduguard   BPDU guard on the interface
  disable     Disable stp on the interface
  guard       Guard type Loop or Root or None
  link-type   Detemine link type based on media duplex of this interface
  msti        Spanning Tree Subsystem
  port        Set port type
  rapid-pvst  Spanning Tree Rapid-pvst Subsystem
  rstp        Set rstp parameters for interface
  vlan        Select vlan range option

Any ideas, please?

Thanks,

Mark

Sorry some information about OS10

Spanning Tree | H3 headings | Dell Technologies Info Hub

Bingo, thanks Marco - that document tells me that `spanning-tree port type edge` on OS10 achieves the equivalent job of `spanning-tree portfast` on OS9.

Could the OS10 documentation be updated, please? Pages 558, 563 and 567 in Dell SmartFabric OS10 User Guide Release 10.6.0 all refer to enabling port-fast, when presumably they should be recommending changing the port type to edge.