I have a brand new Optliplex 5070 with vertical DVD drive. I am trying to install new software and inserted a disk. Nothing happened and finally I opened the drive door and the disk was gone. I tried repeatedly opening and closing the drive but the disk never appeared. I disconnected the PC and held it upside down, etc. and the disk never showed up. Peering into the tiny slot I cannot see the disk. I inserted another disk but the PC does not recognize the drive at all. the drive does not show up on Explorer. Any suggestions? Thanks.
I was able to remove the disk. I got out my jeweler’s tools and carefully removed the drive tray from the rails it slides out on. Then I was able to peer inside and I could see the hole in the center of the disk. I hooked it with a slender tool and pulled it out. After putting everything back together, I was able to successfully use the drive and disk to install the software. Lesson learned is to be very sure the disk has securely snapped in place before closing the drive.
With a new system, best to call Dell support. And when posting here specify which version you have such as Micro, Small Form Factor, etc.
If you want to dig into it, the service manual details how to remove/install an optical drive. Since its the vertical model (basically a laptop style optical drive) the lost disc is probably inside the case.
Here is the link to the Dell 5070 support, select the Service Manual for your specific version.
I have never seen this particular issue, but without knowing what kind of a disc it is, it is harder to troubleshoot. And ... what did you find by opening the case? Chances are good that it fell down inside of it.
Those smaller optical drives are very hard to reach especially if the device is on its side. I have the same issue, though have never had the disk fall in.
CDH3218
4 Posts
2450
0
Posted February 22nd, 2020 09:00
I was able to remove the disk. I got out my jeweler’s tools and carefully removed the drive tray from the rails it slides out on. Then I was able to peer inside and I could see the hole in the center of the disk. I hooked it with a slender tool and pulled it out. After putting everything back together, I was able to successfully use the drive and disk to install the software. Lesson learned is to be very sure the disk has securely snapped in place before closing the drive.