I started a RP4VM installation where the customer was using RP/SE and SRM.  Quickly realized they do not play nice together and I had to tear down the RP/SE with SRM install first.  I had removed the MOB com.emc.recoverpoint.vwc and then started the install of RP4VM again.  Great everything worked and I could then start protecting the VM's with RP4VM inside vsphere console and everything is good, except that it shows 2 clusters and 1 is disconnected.  I was looking through the uninstall guide for RP4VM and it says to remove the MOB CustomFieldsManager for the config.RecoverPoint_TOKEN;XXXXXXXXXXXX.  Great that is not hard I can do that, BUT I see 2 of them and there are 2 clusters.  One is working and the other is disconnected, so how do I determine if the cluster is working is config.RecoverPoint_TOKEN;XXXXXXXXXXXX or config.RecoverPoint_TOKEN;YYYYYYYYYYYY?  I am a little scared that if I remove the wrong one then I will break the installation, but I would like to get the disconnected one out of the system.  Does anyone know how I can translate the token back to a specific cluster?