UNSOLVED
Jumbo frames on Unity
Hi,
I am having a tough time trying to find a way to configure jumbos on a particular trunked in VLAN on a Unity 300.
The 2 ethernet ports we could physically connect on each SP are each in a LAG with several VLANs trunked in. I can't run jumbos on all of them because the network paths simply don't support it,.but the one VLAN where I want to run them - there's no way to configure that interface specifically is there? I mean, did EMC really limit MTU configuration ONLY at the physical NIC level? On the VNX's and every other NAS we have this isn't the case, I find this hard to believe.
thanks
I have not opened a support ticket as I thought maybe someone had tried this already. Like I noted, the VNX's had this capability so why this was not carried forward to this code base makes no sense to me, unless the VNXe's never had it either.
I guess I will open a case and see what comes from it.
Rainer_EMC
6 Operator
•
8645 Posts
1854
0
Posted May 24th, 2019 07:00
can you describe your use case - i.e. why you want Jumbo frames only on some interfaces ?
DELL-Sam L
Community Manager
•
8058 Posts
•
34386 Points
1962
0
Posted May 13th, 2019 10:00
Hello downhill2,
I am not aware of any way to configure a single interface on a unity system. Have you tried to contact support, or is your warranty expired on this system?
Please let us know if you have any other questions.