Unsolved
This post is more than 5 years old
23 Posts
0
391780
USB drive not detecting by Wyse Thin Client
Hi Team ,
i am using Wyse thin Client D10D with Vworkspace 8.0MR1. VDi are working fine with Wyse Thin client D10D. Some of my user want access to Usb drives for external data acess . USB device access to VDI is allowed under connection policies.Usb is redirection to VDi from thin client is working fine . small size USB drives are visible and accessible in VDi .
But large size harddisk are not working which is suppoting USB interface 3.0 .Even 2.0 is also not visible inside VDI.
do i need to configure some setting so USB redirection work properly for 500 Gb and 1Tb USb disk also.
Thanks
DELL-Sam H
57 Posts
1
January 16th, 2015 09:00
Hi Ravi,
I haven't run into this issue before but I've rarely seen such large disks redirected into VDIs. Is this something that happens regularly? If so maybe a mapped network drive would provide better performance?
Do you have "auto connect to local devices" ticked for disks on the D10D?
Are these devices redirected when using a Windows end point? If you try from a Windows end point, make sure to use our latest 8.5 connector as we added support for USB 3.0 http://documents.software.dell.com/DOC252107
Thanks, Sam
Joacbe
1 Message
0
August 12th, 2015 04:00
I'm not using vWorkspace but facing the very same issue with D10D devices: usb pen drives are perfectly detected, however as soon as I plug in a mass storage USB external HDD, I can see it detected in the D10D logs but not as a regular HDD. It then fails to be mapped into the user's session.
I haven't found any solution so far :(
hrajgor
2 Posts
0
September 17th, 2015 02:00
Hi Guys,
Are they formatted as NTFS? this has been our issue here, FAT32 Formatted Drives work straight away, NTFS drives are not working at all no matter what i do
Regards