2) I did not clearly understand your question, If there is a command in OMSA command line then you can use OME to send commands through the remote task feature. There is an option called create command line task. See if that helps. You can find whitepapers on how to use remote task feature at http://en.community.dell.com/techcenter/systems-management/w/wiki/1989.openmanage-essentials.aspx
3) If you mean the hardware logs for the server, yes OME can. In the device tree, navigate to the specific server and then click on hardware logs tab which appears on the right hand side. If you want to receive SNMP alerts, then you will have to configure your server with trap destination to be set as OME IP. This way you will automatically receive SNMP alerts in OME.
Write-Eventlog -computername MyComputer -logname System -source Server Administrator -entrytype Warning -eventID xxxxx -message "Disk Drive 50% Full"
And in event viewer under the Administrative Events i will see the alert created.
I would like to use PowerShell to add a similar alert to the Hardware Log in OMSA.
3) I was wondering if OMSA/OME can pick up the Event Viewer SEL logs (so i can grab Application/System/Security warnings when they arise. I understand you can use Dell Support Assist, but that requires the internet in order to setup. I do not have the internet on any of my servers, so i cannot use this.
DELL-Pupul M
2 Intern
•
1004 Posts
1037
0
Posted August 20th, 2014 02:00
Hi and thanks for the post,
I will try to answer your questions one by one.
1) It would be great if you can post this question on a general forum so that it can be answered correctly.
http://en.community.dell.com/techcenter/systems-management/f/
I am not sure on the EMC part
2) I did not clearly understand your question, If there is a command in OMSA command line then you can use OME to send commands through the remote task feature. There is an option called create command line task. See if that helps. You can find whitepapers on how to use remote task feature at http://en.community.dell.com/techcenter/systems-management/w/wiki/1989.openmanage-essentials.aspx
3) If you mean the hardware logs for the server, yes OME can. In the device tree, navigate to the specific server and then click on hardware logs tab which appears on the right hand side. If you want to receive SNMP alerts, then you will have to configure your server with trap destination to be set as OME IP. This way you will automatically receive SNMP alerts in OME.
Hope this helps