i deploy EMC_Isilon_OneFS_7.2.1.1_Simulator in vsphere 5.5, but when i power on virtual machine and go into console, I have error "storage expansion node is not supported on this chassis type". Please help me!
It looks like version 7.2.1.1 creates three NICs when you convert it, the previous versions only created 2 NICs. If you delete the third NIC in ESX before powering it on it will skip over the NIC options question and will allow you to setup the Isilon cluster. After you do this though I always get the "IFS failed to mount" error and can't continue further. It looks like this version of the simulator is broken, I don't get these errors with 7.2.1.0 or 7.2.0.2 simulators.
Thanks for your help! yes, I convert Workstation vm to vsphere, but I also select vm version 10, not 11 and I receive above error. do you have other way? Please help me!
From the output, it looks like you're looking at the wrong error (which most likely is not an error, but an informational notification). It's asking you to choose your NIC layout, not asking about the storage at all. That said, I'm not sure what it should be for the simulator.
Hi Carlilek! Thanks for your help! I have try to select one NIC but after it not display to configure cluster, it have list 3 options: use ssh, reboot. I will upload image later. Can you have different way? Please point to me!
As an aside, I just downloaded the latest "public" simulator which I think is version 7.2.0.1 and that did not exhibit this behavior. Also, the 7.2.0.1 one actually gives me the option to configure the ext-1 interface whereas the newer one did not.
I'm having the same problem on Workstation 11 (and on ESXi 5.5 via a conversion.) I choose the 3 and 4 nic options to get farther (the others generate an error much earlier in the script.) Eventually I get past the OpenSSH message (it never asks me to overwrite) and it just says this:
CASDownload
1 Rookie
•
6 Posts
682
0
Posted November 30th, 2015 20:00
It looks like version 7.2.1.1 creates three NICs when you convert it, the previous versions only created 2 NICs. If you delete the third NIC in ESX before powering it on it will skip over the NIC options question and will allow you to setup the Isilon cluster. After you do this though I always get the "IFS failed to mount" error and can't continue further. It looks like this version of the simulator is broken, I don't get these errors with 7.2.1.0 or 7.2.0.2 simulators.