Hi guys,

I have to configure a new stack with 2 4032f using only 10Gb interface without any external module.

I saw in the manual the following commands to create the stack:

 

console#config
console(config)#stack
console(config-stack)#stack-port fortygigabitethernet 1/1/1 stack
console(config-stack)#stack-port fortygigabitethernet 1/1/2 stack

 

Do you know if is possible apply this configuration on 4 * 10Gb interfaces ?

E.G.

console#config
console(config)#stack
console(config-stack)#stack-port Tengigabitethernet 1/0/21 stack
console(config-stack)#stack-port Tengigabitethernet 1/0/22 stack

console(config-stack)#stack-port Tengigabitethernet 1/0/23 stack
console(config-stack)#stack-port Tengigabitethernet 1/0/24 stack

If so, Will these interface be displayed in the show running after creating the stack?

 

Thank you

 

P.s. why is it a 4032 if it has only 24 interfaces?