Attachment uploads are currently disabled. This is a temporary situation and will resume as normal in the coming days.
Solved!
Go to SolutionPowerPath Not Working
I have an older FC4700-2 that has been retired that we decide to use. I have built a Dell 2650 with dual Emulex LightPulse LP9802 HBA's. I have given the storage group 4 Luns and I am seeing 8 at the server because of the dual path. I have a licensed copy of Powerpath installed but when you go into the Power path administrator I am not seeing any storage arrays, disks, or adapters. It does not working at all. I have tried multiple versions of power path but pretty much the same thing happens with all tried versions. Any ideas?
Thanks
Michael
Thanks
Michael
- I have it to clarion open, 1, enabled and I am now seen the adapters and disk. With 2 hba's in the servers, 2 fiber switches what mode should it be 0,1,2? At 0 I get errors on all adapters in powerpath, mode 1 power path looks to be fine but I'm seeing 16 disks in device manager.
Message was edited by:
Fishgod Allen Ward
6 Operator
•
2124 Posts
187
0
Posted February 2nd, 2007 08:00
Just an FYI... you may or may not still run into trouble with PP 4.5x. EMC dropped support for the FC4700 in v4.5 We were forced to stay at a lower rev until we migrated everything off the old arrays and decommitted them.
If it works for you great, but beware...
dynamox
11 Legend
•
20419 Posts
•
87439 Points
890
0
Posted February 2nd, 2007 08:00