In this video, you will learn how to enable and perform the iDRAC hard reset operation on CPU. To begin, extract the iDRAC Service Module installer file from the Zip file. Navigate to the folder in which the iDRAC Service Module installer file is saved and double-click to install. In the iDRAC Service Module installshield wizard, click 'Next'.
Review the license agreement and 'Accept' to proceed with the installation. Then click 'Next'. Typical Setup Type is selected by default, click 'Next'. Review the information before installing and then click 'Install' to start the installation process. Click 'Finish' after successful installation. Next, open a Powershell console as an administrator.
And then enter the following command at the prompt: Invoke-iDRACHardReset' And then press enter. Then, confirm if you want to proceed with the iDRAC hard reset operation. Here, you can view a message about the successful iDRAC hard reset operation.
