How to Replace Intrusion Switch for PowerEdge T360

This video will demonstrate the replacement procedure of the intrusion switch for the PowerEdge T360.

Prerequisites
Follow the safety guidelines listed in Safety instructions.
Follow the procedure listed in Before working inside your system:
Power off the system and all attached peripherals.
Disconnect the system from the electrical outlet and disconnect the peripherals.
Remove the system cover.

Remove the air shroud.

Removing the intrusion switch module:
Disconnect the intrusion switch cable from the connector on the system board.
NOTE: Observe the routing of the cable as you remove it from the system. Route the cable properly when you replace it to prevent the cable from being pinched or crimped.
Slide the intrusion switch module out of the system slot.

Installing the intrusion switch module:
Align and slide the intrusion switch module into the system slot until firmly seated.
Connect the intrusion switch cable to the connector on the system board.

Install the air shroud.
Follow the procedure that is listed in After working inside your system:
Replace the system cover.
Reconnect the peripherals and connect the system to the electrical outlet, and then power on the system.