Be sure to read and follow the safety guidelines to protect your computer from potential damage and ensure your personal safety. For more information about safety guidelines, see the owner's manual at Dell.com/Support. Before you begin. Turn off the computer and disconnect all the attached peripherals.
Loosen the captive screws holding the base cover in place. Using a plastic scribe, pry the base cover from the palm rest assembly. Starting at the top edge and working your way around to release it from all sides. Now lift the base cover from the palm rest assembly.
If your computer is unable to enter service mode, disconnect the battery cable from the system board to remove the solid state drive 2230. Identify the solid state drive. Remove the screws, securing it. Lift the drive out of the system. And remove the thermal shield. Flip the drive over. Remove the screw to fully disconnect the drive.
To reinstall the solid state drive 2230 align SSD drive with the bracket. Install the screw to secure SSD to the bracket. Flip the drive over. Slide the solid state drive into the slot. Place the thermal shield. And install the screw to secure it. If the battery cable was disconnected earlier, make sure to reconnect it to the system board.
Next, align the base cover with the palm rest assembly and gently place it into position. Tighten all required screws to secure the base cover in place. For more information about your Dell system, visit Dell.com/Support.
