Hi, I'm Jason and I work at Dell Technologies. Today. We're going to show you how to create and manage vines with Hyper V. This is a very basic video introduction on how to do this open up IV manager. And we'll go through on how to create a VM under actions, select new V machine, the new virtual machine wizard star and next type in a new virtual she name this case would probably be test. We can also select a different location if we need to get next, choose a generation of SBM select generation two generation one is for any operating systems that might be older, hit next type in the desired start up memory.
In this case, we would select two gig, we can also select, use dynamic memory for this VM which Hyper V will decide on how much memory will be assigned to the ear, the next select the desired network. The next here, we'll be able to choose the options to create a new virtual disk or use an existing virtual disk or attach a virtual disc manor. We can also select the desired size of the virtual disk. This case will type in 40 gigabytes. Next, here we have the option to choose to install the operating system later or we can choose an ISO like browse and locate the ISO and open it. Next. The last will be a summary screen of what you've just created. Hit finish. So now we've created a new virtual machine.
It will be listed under virtual machines. Next, I'll show you how to start a VM, how to stop a VM, pause, restart, etcetera. So right, click on the virtual machine and click connect. This will open up the virtual console for that VM. Under actions. We can start a VM which will start the actual VM. We can shutdown the VM which will actually shutdown the VM. We can reset the VM which will reboot the VM, we can pause the VM which will pause the actual VM in a state it's currently in and saved the VM. So let's start VM. OK. Now we can shut down the van.
So the power off is like powering is actually powering off the VM. If we perform a shutdown, that will be equivalent to a graceful shutdown. We can reset the VM which would just do a power cycle of the VM. We can also pause of mm and resume the BM. We can turn off the BM. There are also options to perform snapshots. We can also edit the current VM by going to file settings. So just say you've created the VM and you want to make a change to VM.
For example, the memory or the amount of processes that the VM is currently consuming was configured for the virtual disk itself where it's located, the network configuration, the VM name checkpoints or the actual snapshots Beijing location and other options. OK. That's it. Thank you very much. I hope you enjoyed and were able to learn a little bit how to create a new virtual machine and how to start and stop and manage to be VM.
Thank you.
