Prerequisites
Follow the safety guidelines listed in Safety instructions
Turn off the system, including all attached peripherals.
Disconnect the system from the electrical outlet and disconnect the peripherals.
Remove the system cover.
Removing the air shroud:
Holding the blue touch points, lift the air shroud away from the system.
Remove the BOSS card.
NOTE The procedure to remove the BOSS card is similar to the removing an expansion card.
Removing the M.2 SSD module:
Loosen the screw and lift the retention strap that secures the M.2 SSD module on the BOSS card.
Lift the M.2 SSD module and slide it out of the connector on the BOSS card.
Installing the M.2 SSD module:
Connect the M.2 SSD module to the connector on the BOSS card.
Place the retention strap on the M.2 SSD module, and tighten the screw to secure the module.
Install the BOSS card.
NOTE The procedure to install the BOSS card is similar to the removing an expansion card.
Installing the air shroud:
Align the tabs on the air shroud with the slots on the system.
Lower the air shroud into the system until it is firmly seated.
When firmly seated, the memory socket numbers marked on the air shroud align with the respective memory sockets.
Install the system cover.
Reconnect the peripherals and connect the system to the electrical outlet.
Turn on the attached peripherals and then turn on the system.
