Prerequisites
Follow the safety guidelines listed in the Safety instructions.
Power off the system and all attached peripherals.
Disconnect the system from the electrical outlet and disconnect the peripherals.
If applicable, remove the system from the rack.
Remove the system cover.
Removing a GPU fan module:
Press the latch on the GPU fan module.
Using other hand pull out the GPU fan module to disconnect from the connector on the rear fan cage assembly.
Removing the GPU fan cage:
Using a Phillips 2 screwdriver, release the two thumb screws on the rear fan cage.
Using both hands pull the left and right handles outward together and pull the complete module out until the safety latch engages with the chassis.
Push the button on both sides to disengage the latch from chassis, then pull GPU fan cage out of the chassis.
Removing the GPU tray:
Using a Phillips 2 screwdriver, release ten capture screws on both side of the chassis.
NOTE: The screw torque is 10 in-lbs and requires additional effort to release the screws.
Using both hands, rotate the handle and slowly pull the GPU tray toward the rear of the system.
Press and release the safety latch on both sides of the GPU tray.
Hold the GPU lifting handle and pull the tray out from the rear of the chassis.
Removing the GPU:
Press the buttons on both sides of the GPU tray top cover and slide the top cover forward.
NOTE:This step is not applicable for AMD MI300X GPU. Please proceed to Step 2.
Lift the GPU top cover from the GPU module.
Installing the GPU:
Align and place the GPU top cover down.
Push the GPU top cover from the front toward the rear of the GPU tray until it auto-locks by latch on both sides.
NOTE:This step is not applicable for AMD MI300X GPU.
Installing the GPU tray:
Lift and align the GPU tray with the rear of the chassis to ensure correct orientation.
NOTE:Two people are needed to carry the GPU tray from each side.
Using both hands, slowly push GPU tray along the track from the rear of the chassis.
NOTE:The GPU tray will slide forward and connect to the connector.
Using both hands, push the handle until it is in a vertical position and self-locks at the same time
Using a Phillips 2 screwdriver, tighten the ten capture screws on both side of the chassis.
NOTE: The screw torque is 10 in-lbs and requires additional effort to tighten the screws.
Installing the GPU fan cage:
Hold the fan cage module and align it with the rear of the system.
NOTE:Ensure that the TOP side mark on the fan cage is in the correct position.
Press the fan cage module firmly into the chassis until it reaches the hard stop position.
Push the fan cage module into the chassis until the handles touch the middle plane.
NOTE:Ensure that the rear fan cage is level and not slanted.
Rotate the left and right handles inward by hand.
Using a Phillips 2 screw driver, tighten the two thumb screws on the rear fan cage.
Installing a GPU fan module:
Align the GPU fan module with the GPU fan cage wall.
Using both hands push the GPU fan module to the end until it clicks into place.
Replace the system cover.
If applicable, install the system into the rack.
Reconnect the peripherals and connect the system to the electrical outlet, and then power on the system.
