Welcome to Dell em Cric Cisco, how two series, how to configure mds scheduler reference Dell Knowledge article number 320722 This video was created to demonstrate the steps two configure M DS command scheduler. When to do this, there is a need to schedule a job or multiple jobs at a specified time in the future.
The jobs can be executed once at a specified time in future or at periodic intervals before you begin scheduling guidelines. Be aware that the scheduled job can fail if it encounters one of the following situations when the job is being executed. If the license has expired for a feature and the job containing commands pertaining to that feature is scheduled. If a feature is disabled, when a job attaining commands pertaining to that feature is scheduled.
If a module has been removed from a slot and the job has commands pertaining to the interfaces for that module or slot, verify that the time is configured. The scheduler does not have any default time configured. If a schedule is created and jobs are assigned to a but time is not configured, then that schedule is not launched while defining a job, verify that no interactive or disruptive commands. For example, rider race and other similar commands are specified as part of a job because the job is executed non interactively at the scheduled time.
Scheduler terminology.
What is a job? A job is a set of NX OS cli commands that are executed as defined in the schedule? What is a schedule? A schedule determines the time when the assigned jobs must be executed. Multiple jobs can be assigned to a schedule. A schedule executes in one of two modes, one time or periodic, which periodic modes are supported? A job is executed at the user specified periodic intervals until it is deleted by the administrator.
The following types of periodic intervals are supported. The job is executed once a day, once a week, once a month, beginning at the specified start time and thereafter at user specified intervals, days, hours minutes and once at a user specified time steps to configure mdss command scheduler. How to enable the command scheduling feature on switch, connect remotely to the switch via SSH log into the switch, run configure terminal to enter configuration mode, run the command feature scheduler to enable command scheduler exit from configuration mode.
How to define the job for the command scheduler issue configure terminal to enter configuration mode to define the job name and to enter job definition sub mode, run the command scheduler job name, test one where test one is name of the job define the commands that the job needs to run. In the above example, boot flash is specified as a location to save the output. However, it is recommended to use an FTP or TFTP server as the save location because boot flash may become full.
If we run show interface after regular interval. Also by specifying time stamp in the command, it will generate a separate time stamped file periodically exit from sub mode. This saves the job which was created run show scheduler job name test one where test one is the job name, which was created in previous steps. How to specify a periodic job for the command scheduler. Go to configuration mode, run the command schedule or schedule name, show interface. Rare show interfaces. The name of job schedule.
Apparently this command defines a job schedule and enters the sub mode for that schedule. Command job name test one assigns the job that his test one for this schedule specify when the schedule has to run using the command time, start now repeat time stamp. The above example specifies a job that has to be executed after every 15 minutes. The scheduler begins two seconds past the current time. If today is October 7th 2020 the current time is 10 hours, 36 minutes, 22 seconds.
The command begins executing a two seconds past 10 hours, 36 minutes and 22 seconds on October 7th 2020 continues to execute every 15 minutes after that, run the command directory, boot flash to verify that the first file has been generated after two seconds and second file subsequently 15 minutes after that, how to delete the defined schedule, enter configuration mode, run the command, no schedule or schedule name followed by the name of the schedule to delete the defined schedule reference. The following. For more information, knowledge base article number 320722.
Thank you for watching.
