Dell EMC Networking N2000 Series Firmware Version 6.6.0.24
Genstart er nødvendigInstalleretDenne fil blev automatisk installeret som en del af en nylig opdatering. Hvis du oplever problemer, kan du downloade og geninstallere manuelt.
Indholdet på denne side er muligvis blevet oversat automatisk. Udfyld formularen nederst på siden for at give feedback.
Denne fil blev automatisk installeret som en del af en nylig opdatering. Hvis du oplever problemer, kan du downloade og geninstallere manuelt.
If N2000 series switch has an earlier version of firmware (6.0.0.7 or 6.0.0.8 or 6.0.1.3), upgrade switch to the latest version of firmware 6.6.0.24 as it contains multiple bug fixes.
New CPLD version 20 is available in release 6.5.1.1 and later (6.6.0.24) for N2000 Series switches. After upgrading the switches to FW version 6.5.1.1 and later (6.6.0.24), the CPLD can be updated to version 20 from CLI using the command - "update cpld". To update CPLD on stack members, run - 'update cpld ' command from stack master. Please DO NOT power-cycle the switch when CPLD update is in progress. After CPLD update is complete, the switch will reset on it's own. Verify CPLD Version with the command - 'show version' from CLI after switch boot-up completes.
****Below information is applicable ONLY for N2000 switches upgraded to 6.6.0.24 and CPLD Version 15 or 17 or 20 and attempt to downgrade to any prior FW version****
Downgrading N3000 and N2000 Series switches from firmware version 6.6.0.24 with the updated CPLD version 15 or 17 or 20 (Verify CPLD Version with the command “show version” from CLI) to any prior 6.x.x.x version can ONLY be done by downgrading via interim FW version B.6.3.2(N3000_N2000vB.6.3.2.stk) attached to zip file.
With interim FW image version B.6.3.2 running, the switches should be downgraded to CPLD version 13 first before downgrading to any 6.x.x.x version. Please follow the instructions documented in the “Firmware Downgrade” section of "Upgrading Dell EMC Networking N2000 Series Switches From Version 6.x.x.x to 6.6.0.24.pdf" file.
Please refer to the Release Notes for fixes and enhancements available in this release. "Release Notes" are included in the zip file - "Dell_EMC_Networking_6.6.0.24_6.6.0.54_ReleaseNotes_N1100_N1500_N2000_N2128PX_N3000E_N3132PX.pdf".
Anbefalet
Tjek kompatibilitet
Indtast produktoplysningerne for at få vist de seneste driveroplysninger for dit system
Indtast din Dell-servicekode eller -model
Vil du søge efter dit produkt? Indtast et produkt-id.Vis mig hvordan
Søgningen gav ingen resultater.Vi kunne ikke finde nogen match til din søgning. Rediger din søgning for at indtaste en servicekode (B959FS3) eller model (Latitude 5540), og prøv igen.
Denne driver er ikke kompatibel
Denne driver er ikke relevant for det valgte produkt. Vælg et andet produkt for at indtaste dine produktoplysninger for denne driver igen, eller gå til siden Produktsupport for at se alle drivere til et andet produkt.
Log på Windows som administrator for at bruge automatisk scanning. Hvis du allerede er logget på som administrator og får vist denne meddelelse, skal du genstarte enheden.Dit system administreres af din it-administrator, og funktionaliteten kan være begrænset.
Find flere opdateringer. Brug SupportAssist til at finde alle de seneste driveropdateringer til din enhed.
Programrettelser og forbedringer
Fixes: FIELD-4848 CS00010067343 N1148 | 6.6.0.15 | media in Fiber slots showing "unknown" after few days FIELD-4883 CS00010139205 DNSE/N1124P-ON/6.6.0.15/F-4883/Unable to set the ACL match rule to a class if ACL has more then one Rule FIELD-4987 CS00010323786 DNSE/N2000/6.6.0.17 - Configuring description for a port from GUI causes the port to go down FIELD-5037 CS00010386529 DNSE/N2048/6.6.0.10 - Error in GUI when trying to delete or edit vlan while the monitor session configuration is present FIELD-5068 CS00010414469 DNSE/6.6.0.7 - N2000 - VLAN interface fails to release/renew dhcp address FIELD-4870 CS00010237720 DNSE/N1500/6.6.0.15 - Intermittent ping loss to switch causing video application to fail over FIELD-4977 CS00010282531 DNSE/N2048P/6.6.0.15 - N-series doesn't reply with agreement BPDU for the proposal BPDU in RPVST mode FIELD-5163 CS00010536633 N2048P | 6.6.0.17 | Port Speed Changes When Config Applied From GUI
Dell Technologies anbefaler, at denne opdatering installeres under den næste planlagte opdateringscyklus. Opdateringen indeholder ændringer, der skal opretholde systemets generelle tilstand. Den sørger for, at systemsoftwaren forbliver opdateret og kompatibel med andre systemmoduler (firmware, BIOS, drivere og software) og kan indeholde andre nye funktioner.
Fixes: FIELD-4848 CS00010067343 N1148 | 6.6.0.15 | media in Fiber slots showing "unknown" after few days FIELD-4883 CS00010139205 DNSE/N1124P-ON/6.6.0.15/F-4883/Unable to set the ACL match rule to a class if ACL has more then one Rule FIELD-4987 CS00010323786 DNSE/N2000/6.6.0.17 - Configuring description for a port from GUI causes the port to go down FIELD-5037 CS00010386529 DNSE/N2048/6.6.0.10 - Error in GUI when trying to delete or edit vlan while the monitor session configuration is present FIELD-5068 CS00010414469 DNSE/6.6.0.7 - N2000 - VLAN interface fails to release/renew dhcp address FIELD-4870 CS00010237720 DNSE/N1500/6.6.0.15 - Intermittent ping loss to switch causing video application to fail over FIELD-4977 CS00010282531 DNSE/N2048P/6.6.0.15 - N-series doesn't reply with agreement BPDU for the proposal BPDU in RPVST mode FIELD-5163 CS00010536633 N2048P | 6.6.0.17 | Port Speed Changes When Config Applied From GUI
(1) Download the zip file - N2000v6.6.0.24.A08.zip (2) Extract the image file "N2000Stdv6.6.0.24.stk" from the zip file (3) Install the image to the switch by following the upgrade procedure "Upgrading Dell EMC Networking N2000 Series Switches From version 6.x.x.x to 6.6.0.24.pdf" extracted from zip file.
Har du brug for hjælp til problemer med netværksforbindelsen?
Find en løsning i Dells fejlfindingsvejledning for netværk