Download Files
File Format: This file format consists of a BIOS executable file. The Universal (Windows/MS DOS) format can be used to install from any Windows or MS DOS environment.
File Name: Inspiron11_3162_3164_2.0.0.EXE
File size: 5.99 MB
To ensure the integrity of your download, please verify the checksum value.
MD5: 89fc9da1f164f20c007982a1bc29a535
SHA1: 60b0eef15f53c87fb83fa40c1b2948c3e7985c09
SHA-256: 3e161298b47fbab3d93d0c111820e4bf7e28bef89b83703b9a42c08d562f08de
Fixes & Enhancements
Fixes
- Not Applicable.
Enhancements
- Enhance Micron 4G on-board DIMM performance.
- Cannot downgrade BIOS to previous version after flashing this version.
Supported Operating Systems
Installation instructions
BIOS Update Executable for Windows/DOS
Download
1. Click Download File to download the file.
2. When the File Download window appears, click Save to save the file to your hard drive.
Run the BIOS update utility from Windows environment
1. Browse to the location where you downloaded the file and double-click the new file.
2. Windows System will auto restart and update BIOS while system startup screen.
3. After BIOS update finished, system will auto reboot to take effect.
Run the BIOS update utility from DOS environment (Non-Windows users)
1. Copy the downloaded file to a bootable DOS USB key.
2. Power on the system, then Press F12 key and Select "USB Storage Device" and Boot to DOS prompt.
3. Run the file by typing copied file name where the executable is located.
4. DOS System will auto restart and update BIOS while system startup screen.
5. After BIOS update finished, system will auto reboot to take effect.
Run the BIOS update utility from DOS environment if UEFI Boot Mode (Non-Windows users)
1. Copy the downloaded file to a bootable DOS USB key.
2. Power on the system, then go to BIOS Setup by pressing F2 and go to General > Boot Sequence > Boot List Option
3. Change UEFI to Legacy of Boot List Option
4. Click Apply, Exit to save changes and reboot system.
5. Press F12, then Select USB Storage Device and Boot to DOS prompt.
6. Run the file by typing copied file name where the executable is located.
7. After BIOS update finished, system will auto reboot.
8. Go to BIOS Setup by pressing F2 and go to General > Boot Sequence > Boot List Option
9. Change Legacy to UEFI Boot Option.
10. Click Apply, Exit to save changes and reboot system
--------------------------------------------------------------------------------
Note 1: You will need to provide a bootable DOS USB key. This executable file does not create the DOS system files.
Note 2: Please make sure you suspend BitLocker encryption before updating BIOS on a BitLocker enabled system. If you don't enable BitLocker on your system you can ignore it.
Reboot will be required