Version 7.12.09 Fix:
Blue screen during install on ICH using WinXP SP2.
Unable to connect dialing into some RAS servers.
Improve V90 throughput performance.
Driver Installation in Spanish
Version 7.12.08 Fix:
Com application locks after resume from Hibernate
Italy cadenced dial tone failed detection
+PQC setting cannot be set to "3" through the SDK
V.44 Compression cannot be disabled through the SDK
Azalia INF files need to be updated for Security entries
Version 7.12.07 Fix:
Intermittent failure (about 4%) to establish connection on a specific dual PCM (pair gain) line.
New Feature: Add possibility to limit the maximal transmission rate for V.90 or V.34 modualtion depending on a specific region.
Version 7.12.06 Fix:
Intermittent failure (about 10%) to establish connection vs I-Courier server.
Version 7.12.05 Fix:
System crash when rolling back from a newer modem driver to the original Windows XP inbuild modem driver.
System locks up after resumption from the system stand-by state when modem device is in the D3 device state and the "Allow this device to bring the computer out of standby." checkbox is unchecked in the Power Management tab of the Modem Property page.
Loopback test (AT&T1) fails using the QA+Win32 testing application if modem is connected to the phone line.
Intermittent system crash (file Hsf_dp.sys) when establishing connection in answer mode using the V.22bis modulation.
The receiption level is too low when using the MDC 1.5 board.
Failure to hear call progress in the fax mode.
New Feature: The third byte of the SPEEDADJUST registry entry is used to control the connection rate aggressiveness for the V.34 modulation.