Download Files
File Format: This file contains a compressed (or zipped) set of files. Download the file to a folder on your hard drive, and then run (double-click) it to unzip the set of files. Follow the instructions to complete the installation.
File Name: Dell_ControlVault_A17_R267128.exe
File size: 5.07 MB
Fixes & Enhancements
Fixes
- Not applicable.
Enhancements
- Enhanced firmware upgrade robustness if aborted.
- Enhanced to Fingerprint sensor reset algorithm.
- Enhanced RFID config file on single system to improve RFID performance.
Important Information
Requirements
1. The latest Dell Driver Pack must be installed in order for the USHUPGRADE to communicate with the USH.
2. "Application configuration is incorrect" is a result of an old driver pack being installed.
3. The USHUPGRADE is not a stand alone application.
4. It requires all files contained in the firmware directory to update the USH firmware.
5. The files USHUPGRADE uses depend on the particular system.
6. The USHUPGRADE can only be run by a user with Administrator privileges.
7. If running from Vista with User Account Control (UAC) enabled, the USHUPGRADE must be run as an Administrator.
8. GETTING STARTED - Please refer to the \firmware\
eadme.txt file for advanced command line options and result codes.
Supported Operating Systems
Windows 7, 32-bit
Windows 7, 64-bit
Windows Vista, 32-bit
Windows Vista, 64-bit
Windows XP
Windows XP, 64-bit
Installation instructions
Hard Drive Installation (via WinZip) with Setup.exe File
Download
1. Click Download File, to download the file.
2. When the File Download window appears, click Save or Save this program to disk and click OK. The Save In: window appears.
3. From the Save In: field, click the down arrow then click to select Desktop and click Save. The file will download to your desktop.
4. If the Download Complete window appears, click Close. The file icon appears on your desktop.
Install
1. Double-click the new icon on the desktop.
2. The Self-Extracting window appears and prompts you to extract or unzip to "C:\DELL\DRIVERS\NGCT1". (Where 'NGCT1' is the name of the file to be downloaded). Write down this path so the executable (I.e.Setup.exe) file can be found later.
3. The Self-Extractor window appears.
4. Click OK.
5. After completing the file extraction, if the Self-Extractor window is still open, close it.
6. Click Start button and then click Run.
7. Type "C:\DELL\DRIVERS\NGCT1" (where 'NGCT1' is the name of the file) in the Open textbox and then click OK.
8. Follow the on-screen installation instructions.
Reboot will be required