Download Files
File Format: This file format consists of a BIOS executable file. The Universal (Windows/MS DOS) format can be used to install from any Windows or MS DOS environment.
File Name: Precision_7x10_1.04.14.exe
File size: 9.12 MB
To ensure the integrity of your download, please verify the checksum value.
MD5: bebad19219066d1710d71e04bbeef2ef
SHA1: 244731bbc986270fd9e63c71f6325e7f0951b706
SHA-256: 2bcc43b4fe25ff28fdac93bf0981d4dd317b92559df19e15e7e81ff942d360f8
Fixes & Enhancements
Fixes:
- Fixed system will be restarted twice issue when loading BIOS default.
- Fixed unexpected volume up/down behavior by the hot key Fn + page up/down.
- Fixed USB Type C speed issue.
- Fixed Video BIOS Version information in BIOS setup menu.
- Fixed system no error message when attached dock with 240W adapter.
Enhancements:
- Updated to the newer version of the Intel CPU microcode patch.
- Updated Embedded Controller Engine Firmware.
- Updated Intel Video BIOS and Graphics Output Protocol driver.
- Updated "Keypad, By Numlock" information in setup menu.
Supported Operating Systems
Installation instructions
BIOS Update Executable for Windows/DOS
Download
1. Click Download File to download the file.
2. When the File Download window appears, click Save to save the file to your hard drive.
Installation
Run the BIOS update utility from Windows environment
1. Browse to the location where you downloaded the file and double-click the new file.
2. Windows System will auto restart and update BIOS while system startup screen.
3. After BIOS update finished, system will auto reboot to take effect.
Run the BIOS update utility from DOS environment if Legacy Boot Mode(Non-Windows users)
1. Copy the downloaded file to a bootable DOS USB key.
2. Power on the system, then Press F12 key and Select "USB Storage Device" and Boot to DOS prompt.
3. Run the file by typing copied file name where the executable is located.
4. DOS System will auto restart and update BIOS while system startup screen.
5. After BIOS update finished, system will auto reboot to take effect.
Run the BIOS update utility from DOS environment if UEFI boot mode with Load Legacy Option disabled (Non-Windows users)
1. Copy the downloaded file to a bootable DOS USB key.
2. Power on the system, then go to BIOS Setup by pressing F2 and go to "General-Boot Sequence - Boot List Option".
3. Change "UEFI" to "Legacy" of Boot List Option.
4. Click "Apply","Exit" to save changes and reboot system.
5. Press F12, then Select "USB Storage Device" and Boot to DOS prompt.
6. Run the file by typing copied file name where the executable is located.
7. DOS system will auto restart and update BIOS while system startup screen.
8. After BIOS update finished, system will auto reboot.
9. Go to BIOS Setup by pressing F2 and go to "General > Boot Sequence > Boot List Option".
10. Change "Legacy" to "UEFI" Boot Option.
11. Go to "Exit > Exit Save Changes" and reboot system.
Note 1: You will need to provide a bootable DOS USB key. This executable file does not create the DOS system files.
Note 2: Please make sure you suspend BitLockerencryption before updating BIOS on a BitLocker enabled system.
If you don't enable BitLocker on your system you can ignore it.
Reboot will be required
Applies to
Precision 7510 system BIOS
Precision 7710 system BIOS