Download Files
File Format: This file contains a compressed (or zipped) set of files. Download the file to a folder on your hard drive, then double-click it to unzip the set of files. Follow the instructions to complete the installation.
File Name: dltnt.exe
File size: 66.35 KB
To ensure the integrity of your download, please verify the checksum value.
MD5: abd1158bc94268ed9c14c973e5219f99
Fixes & Enhancements
This is the initial release of the driver.
Supported Operating Systems
Installation instructions
After downloading, run the DLTNT.EXE file from within Windows ONLY, and it
will create a floppy disk.
NOTE: This driver package does not pertain to the PowerVault 110T DLT1.
Installation Instructions
1) Shutdown Windows NT 4.0 if it is running and power down the system.
2) Connect the DLT tape drives to the system. Ensure the
SCSI bus is terminated correctly and that there are no target
ID conflicts.
3) Startup the system and log into Windows NT.
4) From the "Start" menu, bring up the Windows NT control panel.
5) Select the "Tape Drive" icon from the control panel. The
system scans for installed tape devices.
6) The Tape Devices dialog box is displyed. All DLT devices
are shown. If the Tape Devices dialogue box indicates that
any DLT tape drive drivers are installed, you must remove
them. Click on the "DRIVERS" tab. Highlight the DLT tape
drivers and select "Remove". When all DLT tape drivers have
been removed, select "Add".
7) In the Install Driver dialog box, click on Have Disk. The
Install from disk dialog box is displayed.
8) Insert the disk containing the QNTMDLT.sys driver into a 3 1/2
inch floppy drive. Change the drive letter in the Copy From
field to the floppy drive and click OK. A new Install Driver
dialog box is displayed.
9) Double click on the
"QUANTUM DLT Driver-Windows NT 4.0-Ver 1.6".
The New Tape Device Found dialog box may be displayed.
10) If the New SCSI Tape Device Found Dialog is displayed
click OK. The Windows NT Setup dialog box is displayed.
11) In the Windows NT Setup dialog box, change the source drive
letter to the floppy drive containing the driver disk. Click
Continue.
12) The Tape Device Dialog box is displayed again. Click OK.
The driver will be installed on the machine.
13) When installation is complete, close the control panel. You
must reboot Windows NT. After rebooting, ensure the driver
is installed by checking the Tape Devices in the control panel.