LSI Logic CERC ATA 100, v.5.35.2, A07

Default Instructions for W2K5352_A07.exe:

This program creates a Windows 2000 driver diskette for the
PERC/CERC controllers. You will need a formatted 3 1/2 inch
floppy diskette for the following procedure.

1) Download the file to a directory on your hard drive. The
file downloaded is a self extracting executable.
2) Double click on the file to run the executable.
3) Click on the unzip button to extract files to the floppy.

Power down the system and install the PERC/CERC card.
Configure the logical drives before proceeding with the
driver install described below.

Installing on a New Windows 2000 Server
---------------------------------------

1) Boot the system using the Windows 2000 CD. As the message

"Press F6 if you need to install a third party SCSI or
RAID driver."

appears, press F6 immediately.

2) Within a few minutes, a screen appears that asks for
additional adapters in the system. Choose 'S'.

3) You are prompted for the driver diskette. Insert the
PERC/CERC Windows 2000 driver diskette in the floppy
drive and press Enter.

4) A list of drivers for PERC/CERC controllers appears.
Select the right driver for your installed controller and
press Enter to load the driver.

5) Press Enter again to continue installation process as
usual.

Adding the PERC/CERC Driver to an Existing Windows 2000 Server
--------------------------------------------------------------

1) Boot the system to Windows 2000. The Found New Hardware
Wizard displays.

2) If you are installing the PERC 3/SC or CERC ATA100/4CH,
click on Next and skip to step 5. Otherwise, click Cancel
on all the new devices.

3) Restart the system from the shutdown menu.

4) The Found New Hardware Wizard displays again when the
system boots to Windows 2000. Click on Next.

5) Select Search for a suitable driver and click Next to
continue.

6) Select Floppy disk drive, insert the PERC/CERC Windows
2000 driver diskette created above and click Next to
continue.

7) Continue to click on Next and finish the installation.

8) The Found New Hardware Wizard screen appears one time for
each PERC 3/SC controller, three times for each PERC
4/Di, PERC 3/DC or PERC 3/DCL controller and four times
for each PERC 3/QC or CERC ATA100/4CH controller. Repeat
steps 5 - 7 for each time the wizard displays to complete
installation of the card.

9) To confirm driver installation, right click on My
Computer and select Manage. Click on Device Manager, then
click on SCSI and RAID controllers to see the newly added
PERC/CERC controller(s) in the list.

Updating the PERC/CERC Driver to an Existing Windows 2000 Server
--------------------------------------------------------------
1) Right click on My Computer and select Manage. Click on
Device Manager, then click on SCSI and RAID controllers.

2) Select Update Driver Tab and follow the instruction to update
driver.

3) After finish driver update, YOU MUST REBOOT YOUR SERVER.