Dell ESM Firmware, A46

ESM v5.28
- Fixed DFCT16896 to log an error when the fan is blocked
before the POST and also to log an event if AC cord is
not present from the Power-up time on Iguana and Slimfast
systems.
- Added code to blink front panel LED when there are voltage
or hard drive failures (or warnings) on Gem backplane.
- Fixed error while returning processor VCORE voltages to
defaults on Opal. DFCT15335
- Added code to support Iguana FC
- Added code to support Viper

SBP v5.43; Rom v5.42
- Added code to blink the front panel LED as soon as the
Drive is removed from a RAID configuration (to indicate
failed array). CHGN13592

PSPB v2.41
v2.41 06-19-00
- When AC power was applied to a system which was turned off before AC
was last removed from system, the power supply fail LED's would some
time turn on until the system was turned on. Power supply fail LED's
now remain off during this power application sequence.
v2.40 06-16-00
- Modified warning thresholds for power supply voltages. This was to
reduce the number of voltage warning alerts generated by
the PSPB.
v2.39 05-26-00
- On a slim system. If Granite tells the PSPB to set the default value
for a Current warning threshold, the warning threshold set is actually
the value for a non-slim system. Setting default warning threshold for
slim system current thresholds now results in the correct vaule being
set.

HOTPLUG PCI v1.18
- No change.

GBP v1.17
- changed mask image initialization to insure all LED outputs
are off at startup.

PE4400 HOTPLUG PCI FPGA v15
- No change